#DIY Plans to Build a Diagonal Corner Base Kitchen Cabinet

DIY Plans to Build a Diagonal Corner Base Kitchen Cabinet

Lumber:

• 1 1 2 at 6
• 2 1 3 at 6
• 1 2 x 2 sheet of 1/2 plywood
• 3 4 x 8 sheets of 3/4 plywood

Cut List:

• 1 3/4 plywood at 31 x 34-1/2 Back
• 1 3/4 plywood at 31 x 35-1/4 Back
• 2 3/4 plywood at 24 x 31 Sides
• 2 3/4 plywood at 34-1/2 x 34-1/2 Shelves
• 2 3/4 plywood at 31 in diameter Lazy Susan Shelves
• 2 1 3 at 14 Face Frame Rails
• 2 1 2 at 31 Face Frame Stiles
• 1 3/4 plywood at 48-13/16 Support
• 2 1 3 at 10 Door Rails
• 2 1 3 at 27 Door Stiles
• 1 1/2 plywood at 10 x 22 Door Panel

Click on the drawings for a larger view!

Step One

Step Two

Cut the pieces for the sides. A 45° bevel will be cut in one side edge of each piece to allow for the face frame on the diagonal. Secure the sides to the back pieces using glue and 1-1/4 pocket hole screws. the beveled edges will face each other.

Step Three

Cut the pieces for the face frame and drill pocket holes in each end of the shorter pieces as well as one long edge of each 1 2 piece (not shown in the drawing ). Assemble the face frame using glue and 1-1/4 pocket hole screws.

Secure the face frame to the beveled edges of the sides using glue and 1 pocket hole screws. Do not use pocket hole screws that are longer as they may poke out the sides! Brad nails can also be used through the bevels into the sides of the frame but they may poke out the back side of the frame.

Step Four

Cut the pieces for the shelves. Drill pocket holes in the shelves as shown. Secure the lower shelf to the side and back pieces first, using glue and 1-1/4 pocket hole screws.

Step Five

Cut the circles for the Lazy Susan shelves. Install the Lazy Susan on the lower shelf first. For detailed instructions on installing Lazy Susan hardware, click here .

Install the upper shelf. It may be easier to install of the pocket holes face up and the shelf is installed from the top of the cabinet (the pocket holes will not be visible). Install the second Lazy Susan.

Step Six

Cut the piece for the support. The support is positioned diagonally across the cabinet and will have 45° angles cut in both sides of each end. Secure the support with 1-1/4 brad nails. Additional supports for the countertop may be added as necessary.

Step Seven

Cut the pieces for the doors and drill pocket holes in each end of the rails. Assemble the door frame using glue and 1-1/4 pocket hole screws.

Set the pocket hole jig for 1/2 material and drill pocket holes in all four edges of the door panel. Secure the panel in the frame using glue and 1 pocket hole screws. The back face of the panel will be flush with the back face of the door frame.

Install the hinges and the cabinet pull as desired.

Cut a piece of 3/4 plywood, approximately 4 tall, to act as a kick plate once the cabinets are installed.

Have any questions about the DIY plans to build a Diagonal Corner Base Kitchen Cabinet? Leave a comment below!